21
9. Adjust the Force Feeder Scraper so that it is flush against the Die Table.
8. Adjust the Take-Off Blade's distance from the Die Table so that it is 1/3 of the tablet's height.
9. Tighten the Force Feeder's bolts.
10. Reinsert the Hopper to Force Feeder Connecting Pipe and the Hopper into the Force Feeder.
11. Tighten the Powder Shutoff Gate's bolt.
5. Loosen the Force Feeder Height Adjustment Base with an Allen key.
6. Adjust the three Force Feeder Height Adjusters with a wrench/by hand.
6.1 Note: To raise the Force Feeder Adjustment Base, turn counterclockwise. To lower the
Force Feeder, turn clockwise.
5
6
7. Place a level on the Force Feeder Adjustment Base and make any necessary adjustments to
ensure that it is flat.
8. Place the Force Feeder back on the Force Feeder Adjustment Base and run a feeler gauge
underneath the Force Feeder to determine the adjustment.
8.1 Note: Start at 0.15 mm and raise appropriately if there is no powder waste/damage to
the Force Feeder Adjustment Base. If there is waste, lower it.
