LEYBOLD ECODRY plus 25, Руководство по эксплуатации

Страница: 20 / 64

WARNING: HEAVY OBJECT
Push-pull hazard with strain injury. Push or pull the pump system only for short
distance and over flat surfaces. Lift the system with a correct lifting equipment or two
persons must lift if the floor is uneven or there are obstacles present.
WARNING: EXHAUST BLOCKAGE
Risk of injury or damage to equipment. A peak pressure of 3 bar(g) can be generated
in the pump if the exhaust or pipework attached to the exhaust are blocked.
WARNING: HAZARDOUS SUBSTANCES
Risk of injury or damage to equipment. The pump is intended for clean applications
only. It is not suitable for use with hazardous production materials.
CAUTION: INSTALLATION SAFETY
Risk of injury or damage to the environment. Follow all local legislation when the
pump is installed or removed to reduce the impact of the pump on the environment.
CAUTION: HIGH NOISE LEVEL
Risk of hearing damage. When the pump is operating and is not connected to the
vacuum system (with open inlet) the noise level may exceed 85 dB(A).
CAUTION: CONDENSATE DRAINAGE
Risk of damage to equipment. Use a catchpot to prevent the drainage of condensate
back into the system. Condensate that drains back into the system could damage the
pump.
Obey the instructions that follow when you install the pump:
▪ Make sure that there is no blockage to access the pump electrical
supply cable or the other controls.
▪ Make sure that there is a minimum air gap of 100 mm on all sides of
the pump to allow effective air circulation.
▪ Make sure that the system is on a firm and level surface that can
support the mass of the pump.
▪ Make sure that the system is installed away from combustible
materials.
▪ Level the pump to a maximum of 5 degrees (measured at the pump
inlet).
▪ You must do a risk assessment of the location and make sure that you
can move the pump safely and as per the local and national manual
handling guidelines.
To move the pump:
300902516_002 - 10/2020 - © Leybold
20
Installation