Leyard Tocuhboards Planar UltraRes Series, Руководство пользователя

Страница: 40 / 88

Turning the Display On
36 Planar UltraRes Series User Manual
To change the IR code on the remote, use the following procedure:
1 Press and hold the CODE button on the remote control until the LED on the
remote lights solid red (approximately five seconds).
2 Enter a new five-digit code between 00000 and 65535. Include leading zeros for
codes with four or fewer digits; for example, enter 255 as 00255.
3 The LED turns off to confirm the code change. If you enter an invalid code, the
LED flashes for three or four seconds. Try again, entering a valid code.
Note: The code must match the IR Remote ID Code setting. See page 58.
Turning the Display On
1 Insert the power cord into the display and into the power outlet.
2 Ensure the AC switch is set to “—“.
3 Press the ON button on the remote or the power button on the keypad.
Turning the Display Off
With the power on, press the OFF button on the remote or the power button on the
keypad to put the LCD panel in a standby mode. To turn off power completely, turn
the AC switch to “O” or disconnect the AC power cord from the power outlet.
Note: The display may automatically turn off the backlight or enter standby mode if no
signal is present for a certain period of time. See the description of the Power Saving Mode
setting on page 49 for more information.
Adjusting the Volume
1 Using the remote, press the
VOL
+ or
VOL
- to increase or decrease the volume.
You can also use the Up and Down keys on the remote and keypad to increase or
decrease the volume.
2 Press the
MUTE
button to temporarily turn off all sound. To restore the sound,
press the
MUTE
button again.
Note:
The analog audio out is variable. S/PDIF is fixed.