Lexus RC F, Руководство пользователя

Страница: 380 / 447

378
RC F̲OM̲(GE)̲1903
7-2. Steps to take in an emergency
air release cap into the valve to let some
air out.
3 Disconnect the hose from the valve,
remove the air release cap from the
hose and then reconnect the hose.
4 Turn the compressor switch on and wait
for several seconds, then turn it off.
Check that the air pressure indicator
shows the recommended level.
(

P.400)
If the air pressure is lower than the rec-
ommended level, turn the compressor
switch on again and repeat the inflation
procedure until the recommended
pressure is reached.
WARNING
■
When fixing the flat tire
Observe the following precautions.
Failure to do so may result in death or
serious injury.
●
Stop your vehicle in a safe and flat
area.
●
Do not touch the wheels or the area
around the brakes immediately after
the vehicle has been driven.
After the vehicle has been driven, the
wheels and the area around the brakes
may be extremely hot. Touching these
areas with hands, feet or other body
parts may result in burns.
●
Connect the valve and hose securely
with the tire installed on the vehicle.
• If the hose is not properly connected to
the valve, air leakage may occur or
sealant may be sprayed out.
• If the hose comes off the valve while
inflating the tire, there is a risk that the
hose will move abruptly due to air
pressure.
• After inflation of the tire has com-
pleted, the sealant may splatter when
the hose is disconnected or some air is
let out of the tire.
●
Follow the operation procedure to
repair the tire. If the procedure is not
followed, the sealant may spray out.
●
Keep back from the tire while it is
being repaired, as there is a chance of
it bursting while the repair operation is
being performed. If you notice any
cracks or deformation of the tire, turn
off the compressor switch and stop the
repair operation immediately.
●
The kit may overheat if operated for a
long period of time. Do not operate
the compressor continuously for more
than 35 minutes.
●
Parts of the kit become hot during
operation. Be careful handling the kit
during and after operation. Do not
touch the metal part around the con-
necting area between the bottle and
compressor. It will be extremely hot.
●
Do not attach the vehicle speed warn-
ing sticker to an area other than the
one indicated. If the sticker is attached
to an area where an SRS airbag is
located, such as the pad of the steering
wheel, it may prevent the SRS airbag
from operating properly.
■
Driving to spread the liquid sealant
evenly
●
Drive the vehicle carefully at a low
speed. Be especially careful when
turning and cornering.
RC F_OM_General_OM24838E