Lexus RC F, Руководство пользователя

Страница: 379 / 447

377
7
RC F̲OM̲(GE)̲1903
7-2. Steps to take in an emergency
Wh
en
tr
oubl
e ar
is
es
19 After driving, stop your vehicle in a
safe place on a hard, flat surface
and reconnect the compressor.
20 Turn the compressor switch on and
wait for several seconds, then turn it
off. Check the tire inflation pres-
sure.
If the tire inflation pressure is below
130 kPa (1.3 kgf/cm
2
or bar, 19 psi):
The puncture cannot be repaired.
Contact your Lexus dealer.
If the tire inflation pressure is
between 130 kPa (1.3 kgf/cm
2
or
bar, 19 psi) and a point below the
recommended level: The tire can
be repaired. Proceed to step
21 .
If the tire inflation pressure is at the
recommended level: Proceed to
step
22 .
21 Turn the compressor switch on to
inflate the tire until the recom-
mended tire inflation pressure is
reached. Drive for about 5 km (3
miles) and then perform step
19 .
22 Attach the air release cap to the
end of the hose.
If the air release cap is not attached, the
sealant may leak and the vehicle may get
dirty.
23 Store the bottle in the trunk while it
is connected to the compressor.
24 Taking precautions to avoid sud-
den braking, sudden acceleration
and sharp turns, drive carefully at
under 80 km/h (50 mph) to your
Lexus dealer that is less than 100
km (62 miles) away for tire repair
or replacement.
■
After a tire is repaired with the emer-
gency tire puncture repair kit
●
The tire pressure warning valve and
transmitter should be replaced.
●
Even if the tire inflation pressure is at the
recommended level, the tire pressure
warning light may come on/flash.
■
If the tire is inflated to more than the
recommended level
1 Disconnect the hose from the valve.
2 Install the air release cap to the end of
the hose and push the protrusion on the
A
B
C
RC F_OM_General_OM24838E