Lexus RC F, Руководство пользователя

Страница: 104 / 447

102
RC F̲OM̲(GE)̲1903
2-1. Instrument cluster
■
Eco driving meter
●
The number of blue segments displayed
on the eco driving meter
decreases/increases depending on the
vehicle acceleration. Use this meter as a
guideline when you wish to drive in an
eco-friendly manner that reduces fuel
consumption.
However, on a downward grade where
the vehicle can accelerate without the
accelerator pedal being depressed, the
eco driving meter may not display the
eco-driving state correctly.
●
When the shift lever is moved to P, N or
R, the segments will turn gray and the eco
driving meter will not operate.
■
Dimming the analog speedometer
lighting
The analog speedometer lighting will be
dimmed when the ambient light is bright,
such as during the daytime, and SPORT S
or SPORT S+ mode is selected.
■
Outside temperature display
●
In the following situations, the correct
outside temperature may not be dis-
played, or the display may take longer
than normal to change:
• When stopped, or driving at low speeds
(less than 20 km/h [12 mph])
• When the outside temperature has
changed suddenly (at the entrance/exit of
a garage, tunnel, etc.)
●
When “_ _” or “E” is displayed, the system
may be malfunctioning.
Take your vehicle to your Lexus dealer.
■
Pop-up display
●
In some situations, such as when a switch
operation is performed, a pop-up display
will be temporarily displayed on the
multi-information display.
●
Some pop-up displays can be set on/off.
(

P.112)
■
Liquid crystal display
Small spots or light spots may appear on the
display. This phenomenon is characteristic
of liquid crystal displays, and there is no
problem continuing to use the display.
■
Customization
The meter display can be customized on
the multi-information display. (

P.404)
WARNING
■
The information display at low tem-
peratures
Allow the interior of the vehicle to warm
up before using the liquid crystal infor-
mation display. At extremely low temper-
atures, the information display monitor
may respond slowly, and display changes
may be delayed.
For example, there is a lag between the
driver’s shifting and the new gear number
appearing on the display. This lag could
cause the driver to downshift again,
causing rapid and excessive engine brak-
ing and possibly an accident resulting in
death or injury.
NOTICE
■
To prevent damage to the engine and
its components
●
Do not let the indicator of the tachom-
eter enter the red zone, as it repre-
sents the engine speed range which
exceeds the maximum safe engine
speed.
●
In the following situations, the engine
may be overheating. In this case,
immediately stop the vehicle in a safe
place, and check the engine after it has
cooled completely. (

P.388)
• The engine coolant temperature
gauge indicator ( ) is in the red
zone and flashing.
• The engine oil temperature gauge
indicator ( ) is in the red zone and
flashing.
RC F_OM_General_OM24838E