IN0DC-15
FI1066
Z11554
Seal Lock Adhesive
IN-4
-
INTRODUCTION
REPAIR INSTRUCTIONS
4
Author:
Date:
2005 LEXUS IS300 (RM1140U)
REPAIR INSTRUCTIONS
GENERAL INFORMATION
BASIC REPAIR HINT
(a)
Prevent damage and maintain vehicle cleanliness by pro-
tective covering on the fender, seat and floor.
(b)
During disassembly, line up parts in the order they were
removed to facilitate reassembly.
(c)
Installation and removal of battery terminal:
(1)
Before performing electrical work, disconnect the
negative (-) terminal cable from the battery.
(2)
If it is necessary to disconnect the battery for in-
spection or repair, first disconnect the negative (-)
terminal cable.
(3)
To prevent damage to the battery terminal when dis-
connecting the terminal cable, loosen the cable nut
and raise the cable straight up. Do not twist or pry
the cable off.
(4)
Clean the battery terminals and cable ends with a
clean shop rag. Do not scrape them with a file or oth-
er abrasive objects.
(5)
Install the cable ends to the battery terminals after
loosening the nut, and tighten the nut after installa-
tion. Do not use a hammer to tap the cable ends
onto the terminals.
(6)
Be sure the cover for the positive (+) terminal is
properly in place.
(d)
Check hose and wiring connectors to make sure that they
are connected securely and correctly.
(e)
Non-reusable parts:
(1)
Always replace cotter pins, gaskets, O-rings, oil
seals, etc. with new ones.
(2)
Non-reusable parts are indicated in component il-
lustrations by the ”
” symbols.
(f)
Precoated parts
Precoated parts are bolts, nuts, etc. that are coated with
a seal lock adhesive at the factory.
(1)
If a precoated part is retightened, loosened or move
caused to in any way, it must be recoated with the
specified adhesive.
(2)
When reusing precoated parts, clean off the old
adhesive and dry with compressed air. Then apply
new seal lock adhesive to the bolt, nut or threads.
