Lexus 2003 SC430, Руководство пользователя

Страница: 88 / 380

INTERIOR EQUIPMENT
71
2003 SC430 from May ’03 Prod. (OM24449U)
3. Press and release the vehicle’s programmed HomeLink
button twice. The garage door may open. If the door does
open, the programming process is complete. If the door does
not open, press and release the button a third time. This third
press and release will complete the programming process by
opening the garage door.
The ceiling mounted garage door opener motor should now
recognize the HomeLink
unit and be able to activate the
garage door up/down.
4. Repeat steps 1 through 3 for each remaining HomeLink
button to program another rolling code system.
INFORMATION
If you register a program in the HomeLink using a
“Rolling Code” type transmitter, the transmitter must be
reprogrammed to use it again.
Programming an entrance gate /
Programming all devices in the Canadian
market
1. Decide which of the 3 HomeLink buttons you want to
program.
2. Place your hand–held gate/device transmitter 25 to 75 mm
(1 to 3 in.) away from the surface of the HomeLink
.
Keep the indicator light on the HomeLink in view while
programming.
3. Press and hold the selected HomeLink button.
4. Continuously press and release (cycle) the hand–held
gate/device transmitter button every two seconds until step 5
is complete.
5. When the indicator light on the HomeLink changes from a
slow to a rapid flash after 20 seconds, you can release both
buttons.
6. Test the operation of the HomeLink
by pressing the newly
programmed button. Check to see if the gate/device operates
correctly.
7. Repeat steps 1 through 6 for each remaining HomeLink
button to program another device.