Lexmark Optra T642n, Руководство пользователя

Страница: 13 / 125

Windows
13
Installing drivers for local printing
Before you can print, you must establish communication between the printer and computer. To do this:
1
Set serial parameters in the printer.
2
Install a printer driver on the attached computer.
3
Match the serial settings in the COM port.
Setting parameters in the printer
1
Press on the operator panel.
2
Press until
Reports
appears, and then press .
Note: For information about serial menus and messages, see the publications CD that shipped with the
printer.
3
Press until
Menu Settings Page
appears, and then press .
The printer returns to Ready .
4
Press .
5
Press until
Network/Ports
appears, and then press .
6
Press until
Serial Standard
or
Serial Option X
appears, and then press .
(
x
) is the number of the serial port.
7
Press until
<Parameter>
appears (where
<Parameter>
is the parameter required for a change), and then
press .
8
Press until
<Setting>
appears (where
<Setting>
is the setting required for a change), and
then press .
Note the following restrictions :
• Maximum baud rate supported is 115,200.
• Data Bits must be set to 7 or 8.
• Parity must be set to Even, Odd, or None.
• Stop Bits must be set to 2.
• Flow Control recommended protocol setting is Xon/Xoff.
9
Press .
The printer returns to
Serial
or
Serial x
.
10
Print a Menu Settings page, and verify the serial parameters are correct.
Note: Keep this page for later use.
a Press on the operator panel.
b Press until
Reports
appears, and then press .
c Press until
Menu Settings Page
appears, and then press .
d Look under the Standard Serial (or Serial Option X if a serial interface card is installed) heading to find the
serial parameters.