Lexmark Optra Color 1200, Руководство по обслуживанию

Страница: 52 / 245

Diagnostic Information
2-13
5050-001
Attendance Messages
Programming Disk The printer is storing resources on the hard disk. Do
not turn the printer off while this message is displayed.
Network Card Busy The network adapter is being reset. The Network
x
Setup menu is not available while this message is
displayed.
Message Action
Close Top Covers Close the printer’s top cover and rear cover. If the
message will not reset, check the two actuating rods
contacting the power supply interlock switch.
Activate the interlock switch with the power on and
replace the power supply (11G0305 115 V, 11G0541
230 V) if the message does not reset.
Insert Tray x Insert the tray indicated (tray 1, 2, or 3). Go to the
“Paper Tray Missing/Size Service Check” on
page 2-35
.
Change
tray
The printer is requesting a different size or type media
than what it detects is in the identified tray (tray 1, 2, 3,
or the multipurpose feeder). The message displays
either the custom media name defined using the
MarkVision utility, the media size, or the media size
and type it is looking for.
To clear the message:
• If the correct paper type is loaded in the tray (but the
Paper Type setting was not changed from the
operator panel), press
Go to continue printing.
• Press Select to ignore the request and print on the
media already installed in the tray.
• Load media of the requested size and type in the
tray indicated.
• If you’re printing on larger paper, make sure the Size
Detection setting is correct.
• Cancel the print job. Press Menu> or <Menu . The
Job Menu is displayed. Press Menu> or <Menu until
Cancel Job appears on the second line. Press
Select.
Message Meaning