Lexmark MS310 4514-220, Руководство по обслуживанию, Страница: 94 / 329

Error code Description Action
200.12 Printhead was not ready for media. Go to “Sensor (input) jam service check” on
page 97 .
200.13 Media at input sensor is not the next media to be
imaged. Go to “Sensor (input) jam service check” on
page 97 .
200.14 Media reached the input sensor before EP was
ready. Go to “Sensor (input) jam service check” on
page 97 .
200.15 Input sensor covered too long. Source = [x]. Go to “Sensor (input) early/late arriving service
check” on page 95 .
200.16 Fuser motor stalled. Go to “Main drive motor control jam service
check” on page 97 .
200.21 No response from paper port driver while waiting
for the source to deactivate the Input Source
Ready flag to indicate it has initiated picking. Go to “Sensor (input) early/late arriving service
check” on page 95 .
200.23 Laser servo never started due to potential conflict
with the transfer servo. Go to “Sensor (input) jam service check” on
page 97 .
200.24 Measured gap at input sensor too small to meet
video delivery requirements. (Not enough time
since prior image finished to start new image). Go to “Sensor (input) jam service check” on
page 97 .
200.25 Input sensor covered too long. Source = [x]. Go to “Sensor (input) early/late arriving service
check” on page 95 .
200.29 Printhead drive control out of range due to an
external event beyond what the control is
designed to handle. Go to “Sensor (input) jam service check” on
page 97 .
200.30 Invalid printhead NVRAM. Go to “Sensor (input) jam service check” on
page 97 .
200.31 Paper, in the middle of a job, at input sensor before
interrupt occurred. Go to “Sensor (input) early/late arriving service
check” on page 95 .
200.32 Detected cover switch bounce. Go to “Sensor (input) early/late arriving service
check” on page 95 .
200.33 Input sensor covered too quickly. Go to “Sensor (input) early/late arriving service
check” on page 95 .
200.38 Interpage servo gap smaller than expected for
galvo offset target evaluation. Go to “Sensor (input) early/late arriving service
check” on page 95 .
200.42 Rogue sheet at ACM sensor while flushing the
paper path prior to declaring tray 1 source empty. Go to “Sensor (input) early/late arriving service
check” on page 95 .
200.44 Page from tray 1 did not reach the input sensor (or
the manual feed sensor, if present) after multiple
pick attempts. Page did make it out of the tray at
least as far as the ACM sensor. Go to “Sensor (input) early/late arriving service
check” on page 95 .
200.84 Image data did not start on time. Go to “Sensor (input) jam service check” on
page 97 .
200.87 During warm up flush, sheet detected too long
over input sensor. Go to “Sensor (input) early/late arriving service
check” on page 95 .
4514-2xx
Diagnostics and troubleshooting
94