Lexmark E260 Series, Руководство по обслуживанию

Страница: 64 / 192

2-36
Lexmark™ E260, E260d, E260dn
4513-200, -220, -230
Messages and error codes
Note: The following message and error codes will be visible only in the print event log in the diagnostic
mode for E260, E260d, and E260dn. See “Diagnostics mode selections” on page 3-8 .
The printer operator panel displays light patterns describing the current state of the printer and indicates
possible printer problems that must be resolved. This topic provides a list of all printer messages and explains
what they mean.
User attendance messages
Paper jam error codes (200-series)
Repeating jams or jam messages can be caused by any of the following:
•
Faulty/contaminated pick solenoids or worn cams of the solenoids.
•
Faulty/contaminated flags or springs.
•
Debris in the paper path.
•
Media not of the specified length.
•
Faulty media feed clutch. See “Media feed clutch service check” on page 2-56 .
Cartridge error codes
Error Description Action
30 Invalid refill Replace the cartridge.
31 Missing or defective cartridge
32 Unsupported cartridge
Paper jam error codes (200-series)
Error Description Action
200.00 Paper jam around input sensor. Remove the PC kit and paper or debris at the input
sensor.
200.01 Classic input jam. The media is too long over the input
sensor. Possible causes include multi-sheet feed, tray
size sensing problem, and media slippage. First, remove the PC kit and paper or debric at the
input sensor. Then, inspect the flag on the input
sensor. It should rotate freely. Replace the sensor if
necessary. Finally, check the paper size settings in
the printer and the driver.
200.02 The main input sensor never became uncovered from
the sheet ahead.
200.03 The video never started on the page at the input
sensor within two inches after hitting the input sensor Check the printhead. See “Printhead service
check” on page 2-67 .
200.04 The media at the input sensor before interrupt
occurred–not enough time elapsed since the printhead
started to expect the printhead mirror motor lock.
Possible causes include bouncy sensor or
exceptionally fast pick– perhaps due to media pre-
staged in the source tray. Carefully remove the tray and notice if the leading
edge of the media is pointed upward and out of the
tray. If so, then inspect the tray wear strips and
replace if necessary.
Inspect the input sensor flag and replace it if it does
not rotate freely or is too loose.
200.06 Imaged page not expected page (bouncy passthru
sensor) Remove the toner cartridge/PC kit. At the front,
remove the upper front guide, and inspect the flag on
the manual input sensor. If the flag is loose, then
replace it. See
“Media manual input sensor
removal” on page 4-42 .