Automatic Learning Function
1. Learn function executes automatically and
runs for approximately 3 minutes when the
batteries are first installed in the receiver.
2. Within these 3 minutes, the receiver picks up
the temperature & humidity signals from the
remote sensor and displays the readings.
Manual-Learning (Searching for Remote Signals)
If a new remote sensor is added or if the signal is
lost (outdoor display blinking), the learning function must be executed again.
1. Press and hold
CHN [4]
for 3 seconds to start.
2. A beep sound indicates that the learning function has started.
3. The 'Channel' symbol will flash and unit will beep as each remote sensor
is detected.
4. Temperature & humidity readings of remote sensor are displayed on the receiver.
Note: Auto/Manual Learn will not operate while the radio controlled clock is receiving DCF77 or MSF
signals.
Copyright © Lexibook 2006
SM1760IM0036 GB5
English
English
5
1
2
3
4
5
6
7
8
GETTING STARTED
SETUP
Copyright © Lexibook 2006
SM1760IM0036 GB6
6
LOW BATTERY INDICATION:
If the batteries of the remote sensor are low, the following indicator
will be displayed on the main unit. The indicator will also be displayed on the bottom left corner of the
remote sensorʼs screen. When the main unitʼs LCD display becomes dim, it indicates that the batteries
are low and need to be changed.
Note: if the sensor is exposed to very low temperatures for an extended period of time, the batteries
may lose power which may cause the transmission range to be limited. High temperatures also reduce
the battery performance.
Setting the remote sensor
Unscrew the battery cover and insert batteries to begin the settings.
The house code
will flash for 8 seconds.
Select
a house code
(1-15) by pressing
°C/°F
[8] and then press
SET [7]
. The house code is the frequency signal sent by the
remote sensor to the receiver. The remote sensors for each
receiver must be set to the same house code, and remember to
press
SET
.
The channel
will flash for 8 seconds.
Select a
channel
(1-3) by pressing
°C/°F
[8] and then press
SET
[7]. The channel
function allows the receiver to identify each remote sensor. Each receiver can receive
up to 3 different remote channels. The preferred channel number (1, 2 or 3) for each individual
remote sensor can be assigned. However, channel 1 is used for collecting data from outdoor and
activating the weather forecast symbols. If you only have one remote sensor, please set it at
channel 1 and place it outdoors.
Humidity and temperature will be displayed.
Toggle between °C or °F temperature display by pressing
°C/°F
key [8].
Insert 3 x AA batteries at the back of the main unit.
Notes:
• The SM1760 comes with one receiver and one remote sensor. If you wish to buy additional sensors
please refer to the section ACCESSORIES at the end of this manual.
• Use a different house code if your weather station detects other signals from neighbouring sources.
Else, use default settings: house code = 01 and channel = 01