Levo Combi, Инструкция по эксплуатации

Страница: 30 / 63

30
15
The backrest can be even adjusted asymmetric or sidewise. For further informations
please contact your local specialist.
11.7.2 Adjustment of back shell
The tension of the backrest cushion can be changed as follows:
Peel back the rear cover of the backrest to expose
the adjustment straps.
Put finger through loop as shown and pull the
strap off the Velcro fastener (see picture 15).
Increase or decrease the tension on the strap to
the desired level and press the strap down onto
the Velcro fastener.
Repeat for each strap. When you are satisfied
with the tension on the cushion refit the rear
cover.
11.7.3 Adjustment of the head support (option)
To remove the head support, loosen the screw (B)
with a spanner number 10.
Lift the head support (see picture 14).
To refit the head support, push the guide rail of the
head support into the mounting rail.
Further adjustments of head support
To adjust the angle of the head support, loosen the
screw (A) using a 10 mm screwdriver.
Retighten the screw.
For the adjustment of the head support rake loosen
the screw (A) and retighten it at the desired position.
(See again picture 14).
Important: To mount a head support to a 63
cm/25” or an 80 cm/31.5” back rest ex post there is
a rail extension necessary.
For additional adjustment of the backrest as well as
for information about accessories to the backrest
please contact your local specialist.
14