control. In case the preset settings don’t meet the needs of the user, the control system can be
programmed individually; the maximum speed might be decreased for example.
Warning:
Programming should only be conducted by healthcare professionals with in-depth
knowledge of Penny&Giles electronic control systems. Incorrect programming could result in
an unsafe set-up of a wheelchair for the user. LEVO AG accepts no liability for losses of any
kind if the drive or stability characteristics of the wheelchair are altered without prior
notification and discussion with LEVO AG.
It is in the responsibility of the person programming the control system to make sure that the
stopping distance requirement specified for the country in which the wheelchair will be used
is satisfied. If the braking rate is low, the forward and reverse maximum speed settings may
need to be re-programmed. It is in the responsibility of the person programming the control
system to make sure that the settings are safe and to note any programming changes made.
4.
Repairs: general instructions
Only a LEVO agent or their authorized dealers should carry out servicing and repairs to the
LEVO
combi
.
!
Repairs: For advice in all repairs in Switzerland contact LEVO AG, Switzerland. For all
other countries contact your local LEVO agent. Addresses are given at the front of this
service manual.
!
Major repairs: For all major repairs, e.g. bent or damaged frame, always replace complete
components. Never try to repair damaged steel work or components.
!
Replacement parts: Factory replacement components should be used in all repairs, these
are available from LEVO AG. To order parts see the parts list drawings and the
correlative list, both available at LEVO AG.
5.
Tools & torque settings
The following tools are required to service the wheelchair:
!
Spanners and sockets: 8 mm through to 24 mm.
!
Hexagon key: 2 mm through to 8 mm.
!
Screwdrivers: 1 Nm through to 50 Nm.
!
Phillips head screwdriver and slotted screwdriver
!
Soft headed hammer
!
Snap through tool
45