Leviton N1000-006, Руководство пользователя

Страница: 12 / 30

Chapter 2 Operation
Page 8
N1000-006
Console Setup
Power On
1. Plug the 12V DC adapter into a 110V AC mains outlet.
2. Plug the DC power connector into the DC power jack located on the rear of the console.
3. Plug the DMX signal cable attached to you dimmers into the DMX OUT connector on the rear of the
console.
4. Move the Power Switch on the rear of the console to the On position.
In order to eliminate possible erratic behavior while controlling DMX devices, always use a DMX
terminator, especially when long runs of control cable are used. A terminator is a 90-120 ohm 1/4
watt resistor that is connected between pins 2 (DATA -) and 3 (DATA+) of a male XLR connector.
Internal Battery Operation
The console comes equipped with an internal battery that will allow for up to three hours usage
without being connected to the DC adapter. Make sure to leave the console plugged in for at least five
hours in order to fully charge the internal battery.
When running on the internal battery, the LCD screen will enter a power saving mode and dim if
not used within eight seconds. Pressing any key or pushing a fader will revert the LCD back to its
lit state.
Auto Memory
All programming data will be saved automatically when the console is turned off. Please note that the
data will be lost if the unit is not powered up within seven days.
Console Reset
1. Press and Hold the [CL] and [ENTER] keys while turning Power Switch On. The LCD displays:
2. Press [1] [ENTER] to reset console or Press [2] to abort.
WARNING! ALL RECORDED DATA WILL BE ERASED!
Master Fader and Bump Button
The Master Fader is used to proportionally control the output of all the console channels. For example,
if the level of channel 1 is at 80% and the master is set at 50%, the actual output of channel 1 will be
40%. A Master Fader LED is located directly above the fader to give the user intensity feedback.
A Master Bump Button is located directly below the Master Fader. When pressed, it will bring all levels
being output to zero.
INITIAL DEVICE
1:YES, 2:NO