Leviton A7810, Инструкция по установке и эксплуатации

Страница: 10 / 44

7
5 CONFIGURATION
5.1.2.5
At this point, the cursor on the display will be blinking on the first number in the IP
address on the second line.
5.1.2.6
To change the number, press the Menu button and the display will cycle through the digits
0 9 as well as “.”. Once the correct digit is displayed, press the Select button to advance
to the next digit and repeat the process until all the digits are correct.
5.1.2.7
Once the IP address on the EMB HubLite matches the assigned IP address, press the
Select button once more to return to the main TCP/IP menu.
5.1.3
Set the Netmask, Gateway, and DNS HUBLite(s) addresses as noted in the chart “Network
Address Worksheet” using the same technique as shown above. The only change is that after
Step 5.1.2.3, press the Menu button multiple times to see the Netmask, Gateway, and DNS
setup menus, then push the Select button to set the options.
Note: If DHCP configuration is selected, the IP, Netmask, Gateway, and DNS HUBLite
addresses will be obtained automatically. Simply select the “Enable DHCP” from the first TCP/
IP configuration menu.
5.1.4
After the address information has been set, you must reboot the EMB HubLite . Select the
“(Previous Menu)” option after step B above. The menu will then state that the EMB HubLite
must be rebooted to take effect. Press the Select button to allow the EMB HubLite to reboot.
Once the EMB HubLite has rebooted, the new IP address will be displayed on the console. If
DHCP addressing was specified, the HUBLite assigned address will be displayed.
NOTE: if DHCP is unable to obtain an IP address, the EMB HubLite will use the fallback
address of 192.168.0.100.
5.1.2.4
Press the Select button again to select the IP Address menu:
WEB
VERSION