5
EN
Levenhuk Wezzer PLUS LP40 Weather Station
The kit includes:
base station, 3 sensors, USB cable, user manual, and warranty.
Also required (not included):
2 AAA batteries for each sensor
3 AAA batteries for the base station
Getting started
Base station
•
Connect the power cable to the device and the DC adapter (not included) via a USB plug and connect to the AC power
supply; or
•
Open the battery compartment cover (7) and insert 3 batteries according to the correct polarity.
Close the cover.
•
Wait until the indoor temperature is displayed on the base station.
Sensor
•
Open the battery compartment cover (1). Set the desired channel with the switch.
•
Insert 2 batteries according to the correct polarity. Close the cover.
• To re-establish the sensor connection manually, press
RESET
using a pin.
Sensor connection
•
Place the base station and the remote sensor within the effective transmission range. Ensure that the channels are
assigned after you set up the power supply for the base station and all the sensors.
•
If the reception is successful, the display will show the temperature and humidity of the respective outdoor sensor. If the
values are not received from a channel, "—" appears on the display. Check the batteries and try it again. Check if there is
any source of interference.
•
When changing batteries, replace the batteries first in the base unit, and then in all the sensors, to re-establish the
connection. If an adapter supplies power to any of the devices, briefly disconnect the power to that device when
replacing the batteries. If you change the batteries only in one of the devices (for example, in the sensor), the signal
may not be received correctly.
Caution! Please remember that mains voltage in most European countries is 220–240V. If you want to use
your device in a country with a different mains voltage standard, remember that use of a converter is
absolutely necessary.
NOTE! It is recommended to use an adapter for the continuous operation of the base station, although
battery power is also possible.
NOTE! This weather station can be operated with up to 3 remote sensors. Each remote sensor that is to be
connected must be operated on a different channel. If only one remote sensor is connected, it should be
operated on channel 1.
