WAB-3001/WAB-3002 11b/g Wireless Outdoor Client Bridge/AP
Version 1.0
46
ACK Timeout
: You may specify a value for the acknowledge timeout.
Data Rate: Select a data rate from the drop-down list. However, it is recommended to
select
auto
for the bet performance.
Data Rate
: If you would like to force a data rate, you may select one from the drop-
down list. However, for best performance it is recommended to use the
Auto
setting.
Output Power Level(OFDM/CCK)
: You may have the different application distance
of the device by selecting a value from the drop-down list. This feature can be helpful
in restricting the coverage area of the wireless network.
You can arrange the different data rate in distance in Access Point mode. Please
refer below table. The table only for 11g and 11b/g mix mode
6M-24M
36M 48M 54M
High
ˇ
ˇ
ˇ
Great
Ultra High
ˇ
ˇ
Great
N/A
Super
ˇ
Great
NA
N/A
Extreme
Great
N/A
N/A
N/A
Preamble Type
: For best performance, all devices on the wireless network should
use the same preamble type. However, the wireless network will still function even
though the wrong preamble type is used.
Broadcast SSID
: This is a security feature that is enabled by default. This allows
clients on the wireless network to run a site survey and detect this Access Point.
Select
Disabled
if you do not want this Access Point detected in a site survey.
IAPP
: It is recommended to
Enable
the Inter-Access Point Protocol (IAPP) if you
would like the clients on the wireless network to seamlessly roam between Access
Points of the same SSID.
802.11g Protection
: If your wireless network is using both 802.11b and 802.g
devices then it is recommended to enable this feature so that the 802.11b devices
will not degrade the performance of 802.11g devices.
User Isolation
: Click “
Enabled
” to stop packet transmission between Wireless
Clients.
Click
on
the
Apply Changes
button to confirm the changes. This device will
automatically restart once these changes have been applied.
