- 3 -
English
Hardware Installation
Front Panel LEDs
On
Flash
Off
Normal Operation
NA
No Power
The Powerline network is active.
This means that at least one
other HomePlug Device was
detected.
Data is being transmitted or
received via the Powerline
network.
Powerline network is not available
- no other HomePlug devices were
detected.
Ethernet connection is active
Data is being transmitted or
received via the Ethernet Port.
No Ethernet connection
Wireless connection is active
Data is being transmitted or
received via the Wireless.
No Wireless connection
WPS connection is active
Data is being transmitted or
received via the WPS
No WPS connection
Configuration requires the use of Windows PC. Once configured, any device may be connected to the 200Mbps
HomePlug AV Adapter's Ethernet port. To perform configuration, follow the procedures list below.
1. Connect a RJ-45 Ethernet cable from the 200Mbps HomePlug AV Adapter's Ethernet port to your PC.
2. Connect a RJ-45 Ethernet cable from your xDSL/Cable Modem's Ethernet port to the other Powerline Ethernet
Adapter's LAN Ports.
3. Plug the200Mbps HomePlug AV Adapter into a power outlet.
4. Wait a few seconds for start-up to be completed, and then check the LEDs.
The
LED should be ON.
The
LED will be ON if other HomePlug devices are detected, otherwise it will be OFF.
Ethernet Cable (RJ-45)
Powerline
Room 1
Room 2
ADSL / Cable Modem
PC
Notebook
Internet
