http://www.level1.com
13
3.6 Power Connection
The POE SWITCH is equipped with an internal power supply unit, which allows a power
connection to a wide range of input voltages from 100 to 240 VAC with 50 ~ 60Hz.
To establish its power connection, simply plug the female end of the power cord into the
power connector on the rear of the switch and the male end of the power cord into a suitable
power outlet. Once you have correctly plugged in the power, you can then turn on the Power
Switch to activate the switch.
3.7 Installation Steps
This section describes the step-by-step procedures for PoE setup.
Step1.
Connect the PoE AP device to LAN port
1
, and your PC to LAN port
8
of the POE
SWITCH as the above connection.
Step2.
Set your PC IP address to
192.168.2.100
(This PC IP address must be in the same subnet
192.168.2.x
as the web
management. Should you have problem in setting PC IP address, please refer to
Section 4.1 for setting up your PC IP address.)
Step3.
Enter
"
192.168.2.1
" from PC web browser to connect to web management page as
the following;
Step4.
Enter "
admin
" for username and "
system
" for password.
Step5.
Go to
"
PoE
", and then select "
PoE Setting
".
Step6.
Click on Port No.
1
and
Update
to power on the connected PoE AP device for Port
1.
Содержание FEP-0840
