3.11 Passage Mode
Chapter 3 Operations
Chapter 3 Operations
3.12 System Self-locked Function
When enter wrong codes continuously for 10 times, buzzer gives three “Wu-Wu-Wu-” alarm, red light flickers, the keypad will be
locked for 5 minutes. At this time, keypad can be released by unlocking the door with valid fingerprint.
A
.
When input invalid fingerprint continuously for 10 times, buzzer gives three “Wu-Wu-Wu” alarm, red light flickers, fingerprint
reader will be locked for 5 minutes. At this time, fingerprint reader can be released by unlocking the door with code.
B
.
If code and fingerprint are both invalid caused by wrong operation, system will be locked for 5 minutes. After that, the system
works again.
C
.
When the door is not locked firmly ( the latches are not fully stretch out), the lock will give out a reminding alarm “wu-wu-wu”.
3.13 Reminding alarm
19
18
3.14 Low battery alarm and external power supply
When the sound “do-re-mi-” is heard during opening the lock, it indicates the lock in low battery state. The lock can still be
opened about 100 times by fingerprint or code in this state. If the power run out (neither fingerprint nor code can open),
external power supply or mechanical key can open the lock. It is strongly recommended to replace battery when it is low.
3.15 System Initialization
Through initialization operation, all information in the system is deleted. In this case, any fingerprint can open the lock.
Remove the battery cover, take off one of the four batteries, and press any key to run out the left power.
A
.
Remove the cylinder cover, insert the mechanical key, turn the key and keep holding, connect the power(put the
battery back) at this time, wait for 5 seconds, one long “Di—” sounded and red light turns on which stands for all codes
are cleared.
B
.
Follow B, wait for another 5 seconds, red light turns off, fingerprint window lights up and one long “Di
” sounded, turn
back the key, wait for about 1 second, digital display shows “n n n”, which means all fingerprints are cleared.
—
C
.
Unlock the door with either fingerprint or code, the passage mode is cancelled.
Unlock the door with code, and press “*” before the motor turns back to the original place, buzzer gives a long “Di
”, blue
light flickers every 3 seconds, the lock is under passage mode.
—
A
.
Unlock the door with fingerprint, and press “*” before the motor turns back to the original place, buzzer gives a long “Di”,
blue light flickers every 3 seconds, the lock is under passage mode.
B
.
3.11.1. How to Set Passage Mode
3.11.2. How to Cancel Passage Mode
Passage Mode: door can be opened from outside by simply turning the handle. Under passage mode, blue light
flickers every 3 seconds.
A
.
Press *” continually for 1 second, buzzer gives two short Di-”, red light flickers, the passage mode is cancelled.
“
“
B
.
