(I)GS 63B… - 02
2020/08/19
Mechanical accessories
Flat mounting device – for mounting compatibility with GS 06 fork photoelectric sensors
High mounting device – for uniform tape height with (I)GSU 14 ultrasonic fork sensors
Clamp – for installation in a groove directly at the dispensing edge
Maintenance information
The (I)GS 63B fork photoelectric sensor is largely maintenance free. Depending on the environmental conditions and the used materials,
it may be necessary from time to time to clean the transparent parts in the lower and upper fork of the fork photoelectric sensor. We rec
-
ommend using a soft, moist cloth for this purpose. To protect the surface, cleaning agents containing solvents should not be used for
transparent parts.
Environmental durability
The used materials feature very good resistance to weak acids and bases as well as to UV exposure. Contact with organic solvents is
possible only to a limited extent and only for short times. Resistance to chemicals should be examined on a case by case basis.
Mounting device BT-GS6X.L (part no. 50114381),
flat design, especially for mounting compatibility with
our GS 06 fork photoelectric sensors.
Mounting device BT-GS6X.H (part no. 50123869),
high design, especially if it is desired that the tape
pass through at a uniform height between our
(I)GSU 14 and the GS 63B.
The BT-GS6X.DT clamp (part no. 50128583) is re
-
quired for fastening the sensor at an arbitrary posi
-
tion in a groove. Connect clamp to sensor as shown
and secure at the desired position by uniformly
screwing in the stud screws.
BT-
GS6X.DT
Sensor
System-side
mounting plate
with groove
BT-GS6X.DT
Sensor
System-side
mounting plate
with groove
(I)GS 63B
