04
ASSEMBLING YOUR
GLOW RINGS
If you already have a Farmstand, begin by
unplugging your Farmstand, removing the lid,
diffuser cap, fill port cap, gasket, and all modules
except for the first one. If you are setting up a new
Farmstand follow the Farmstand Assembly guide
and add just one module.
For all indoor Farmstands
we recommend placing it on a mat to avoid water
dripping o
ff
plants and onto the
fl
oor.
Set aside your top single-cabled Glow Ring (you’ll
use
this last). The two ends of the dual-cabled rings will
arrive screwed together. You will need to unscrew
them in order to connect them to the rings above and
below. Pass the connector side of the power supply
cord through the fill port opening and up through the
center module hole. Make sure the cord goes down
before up, creating slack in the cord.
Attach the first dual-cabled Glow Ring™ to the top
of the first module. Once attached, connect the ring
cable to the power supply cable. The cap should be
screwed until it meets the tip of the arrow. A tight
connection will protect from water damage and is
important for the longevity of the lights.
1
Power Supply
Power Supply
2
3
Dual-Cabeled
Glow Ring
Power Supply
Cable Cap
