04
05
ASSEMBLING YOUR
GLOW RINGS
Get your next module level ready and feed the longer,
non-connected Glow Ring cable up and through the
center hole before you attach the second module to
the first Glow Ring.
Hint:
It’s easier to feed the cable
through the module center before locking the module
in place.
Repeat step 3 & 4 for each dual-cabled Glow Ring and
module, and save the top single-cabled Glow Ring
for last. The short connector cords should always
connect to the lower ring, and the longer connector
cords should always thread up to the ring above.
Attach the single-cabled Glow Ring to the top module
and connect the long cable from the ring below to
the single cable connection. There should not be an
unconnected cable once all Glow Rings are installed.
Any unconnected cables will cause damage to the
device.
4
If you already have a Farmstand, begin by
unplugging your Farmstand, removing the lid,
diffuser cap, fill port cap, gasket, and all modules
except for the first one. If you are setting up a new
Farmstand follow the Farmstand Assembly guide
and add just one module.
For all indoor Farmstands
we recommend placing it on a mat to avoid water
dripping off plants and onto the floor.
Set aside your top single-cabled Glow Ring (you’ll use
this last). The two ends of the dual-cabled rings will
arrive screwed together. You will need to unscrew
them in order to connect them to the rings above and
below. Pass the connector side of the power supply
cord through the fill port opening and up through the
center module hole. Make sure the cord goes down
before up, creating slack in the cord.
Attach the first dual-cabled Glow Ring™ to the top
of the first module. Once attached, connect the ring
cable to the power supply cable. The cap should be
screwed until it meets the tip of the arrow. A tight
connection will protect from water damage and is
important for the longevity of the lights.
1
Power Supply
Power Supply
Power Supply
Dual-Cabeled
Glow Ring
Top Single-Cabled
Glow Ring
2
3
5
Power Supply
Dual-Cabeled
Glow Ring
6
Power Supply
Cable Cap