Page 7 of 15
STEP 12:
STEP 17:
At each
corner of the
trailer, attach
one end gate
body latch.
[Fg. 21]
Attach end gates
[L]
using snap pins.
[Fg. 25]
At four corners of
the trailer, adjust
end gate support
brackets so that
end gate fits snug.
Tighten securely.
For each side of the trailer, weave the electrical wire
in and out of u-tubes [U2]. Secure at two or three
spots along frame tube [H] with zip ties provided.
[Fg. 27]
Install Side Lights. [Fg. 28]
Install tail Lights using the supplied protective plastic
conduit.
Be sure to match the wire colors.
[Fg. 29]
[Fg. 21]
[Fg. 25]
[Fg. 27]
[Fg. 28]
[Fg. 29]
TOOLS: TWO 1/2” WRENCHES
TOOLS: POWER DRILL WITH PHILLIPS HEAD BIT
TOOLS: 5/16IN WRENCH
U1
&
U3
STEP 16:
Attach one tail
light bracket
on each side
of the rear
trailer. [Fg. 26]
[Fg. 26]
TOOLS: TWO 1/2” WRENCHES
U3
STEP 14-15:
At the rear of
each frame
tube
[H]
,
install end
gate support
hardware as
shown. [Fg.
24]
[Fg. 24]
TOOLS: ONE 1/2” ALLEN
WRENCH, ONE 1/2” WRENCH
U3
H
F
STEP 13:
Attach two end gate latches (one on each side) to
each end gate
[L]
. [Fg. 22]
Apply peel n’ stick bubble trim to the inside of the
both end gates. [Fg. 23]
RECOMMENDED
for best adhesive bond
Clean the metal surface with rubbing alcohol and
allow it to dry.
[Fg. 23]
[Fg. 22]
TOOLS: TWO 1/2” WRENCHES
L
L
