PAGE 4 OF 5
CARRIER INSTALLATION
STEP 1:
Install Foam Cushions [
L
] on
ends of Horizontal Legs [
B
]
as shown. [DETAIL 8 & 9]
STEP 2:
Center and place the BikeTree inside the Carrier with
the Horizontal Legs [
B
] running perpendicular to the
length of the carrier. [DETAIL 10 & 11]
STEP 3:
Remove the End Cap and the highest Upper
Wheel Cradle [
H
] located at the top of each
Wing [
G
]. On the inside of the Wing, slip the
looped Connection End of the Cam Buckle
Strap [
M
] around the Wheel Cradle and
reconnect the Cradle with Cotter Pin [
F
].
Reinstall End Cap over Cam Buckle Strap
[
M
]. Complete for both Wings. [DETAIL 12 &
13]
STEP 4:
Connect the
S-Hook End
of the Cam Buckle
Strap [
M
] to the Carrier’s provided tie down
position with the S-Hook facing away form
the carrier. Using the
Slack Side
, fully tighten
Cam Buckle Strap [
M
] evenly on both sides
to remove shifting. [DETAIL 14 & 15]
PRES
S
Connection Side
Slack Side
M
S-HOOK CONNECTION MUST ALWAYS
FACE THE EXTERIOR OF THE CARRIER AS
SHOWN. [DETAIL 14]
FAILURE TO USE THE
CONNECTION SIDE
OF THE CAM BUCKLE STRAP [
M
] WHEN SECURING THE WINGS TO THE
CARRIER MAY RESULT IN LOSS OR DAMAGE PRODUCTS AND/OR PERSONAL INJURY
WARNING:
WARNING:
L
M
G
B
L
DETAIL 8
DETAIL 10
DETAIL 12
DETAIL 14
DETAIL 11
DETAIL 13
DETAIL 15
DETAIL 9
H
F
