PAGE 2 OF 5
STEP 2
STEP 1
Attach Adjustable Rubber Straps [
K
] to the
Upper Wheel Cradles [
H
] and Lower Wheel
Cradles [
J
] With the hammerhead end
facing away Peg. [DETAIL 2]
To attach Cradle Assembly [
H
] to
Wing [
G
], remove Small Cotter Pin [
F
], insert
through hole, and reattach Small Cotter Pin
[
F
] as shown in [DETAIL 3].
NOTE: Foam Cushion [
L
] position is not
fixed. You can slide pads on Wing [
G
] to
expose additional holes.
Where you choose to attach each cradle
assembly will depend on the size and shape
of the bicycle(s) to be transported. Attach one Upper Cradle assembly [
H
] to
each side of each Wing [
K
] (two cradle assemblies per wing).
Loosen and slip two Lower Wheel Cradles [
J
] onto the Wing [
G
] from below
the Foam Cushions [
L
] with each Peg matching the direction of the Upper
Cradle Assemblies [
H
] as Shown [DETAIL 4].
WARNING:
ALWAYS MAKE SURE EACH
CRADLE ASSEMBLY IS HELD IN
PLACE WITH A SMALL COTTER PIN
[
F
] AS SHOWN IN DETAIL 3.
DETAIL 1
Connect the V-Base [
A
] to the
Horizontal Legs using 13 mm Hex
Bolts [
D
] and 13 mm Lock Nuts
[C
]
as shown [Detail 1].
A
K
H
C
D
DETAIL 2
DETAIL 3
K
K
G
J
H
F
F
L
DETAIL 4
J
G
H
