17
CMVETH01B
Commissioning
4.2 Configuring the SMV EtherNet/IP Module
4.2.1 Connecting
With the drive power disconnected install the EtherNet/IP module and connect the network cable as
instructed in the preceeding sections. Ensure the drive Run / Enable terminal is disabled then apply the
correct voltage to the drive (refer to the drive's user manual for voltage supply details).
4.2.2 Setting the Network Protocol
P400 - Network Protocol
Default: 0
Range: 0 to 5
Access: RW
Type: Integer
Set P400 = 5 (Ethernet)
Some SMV option modules are capable of supporting multiple protocols; therefore it is necessary to set the
required protocol. The option module is only initialised after a protocol has been selected.
4.2.3 IP Address
P410 - P413 IP Address
Default: 192 168 124 16
Range: 0 - 255
Access: RW
Type: Integer
Set P410 - P413 to the required value. The default address is 192.168.124.16.
Each node on the network must have an individual address, if two of more nodes have duplicate addresses
the network will not function correctly. After changing this setting, the drive must be power cycled in order
for the new IP address to take effect.
4.2.4 Network Mask
P414 - P417 Network Mask
Default: 255 255 255 0
Range: 0 - 255
Access: RW
Type: Integer
Set P414 - P417 to the required value. The default address is 255.255.255.0.
4.2.5 Gateway Address
P418 - P421 Gateway Address
Default: 192 168 124 1
Range: 0 - 255
Access: RW
Type: Integer
Set P418 - P421 to the required value. The default address is 192.168.124.1.
4.2.6 Multicast Address
P422 - P425 Multicast Address
Default: 239 64 2 224
Range: 0 - 255
Access: RW
Type: Integer
The EtherNet/IP Master sets the multicast address. If desired, this can be set manually using parameters
P422 - P425. The default address is 239.64.2.224.
