P94MOD01B
The documentation contains information about installation in compliance with EMC (shielding, grounding, filters
and cables). These notes must also be observed for CE-marked controllers.
The manufacturer of the system or machine is responsible for compliance with the required limit values
demanded by EMC legislation.
Operation
Systems including controllers must be equipped with additional monitoring and protection devices according to
the corresponding standards (e.g. technical equipment, regulations for prevention of accidents, etc.). You are
allowed to adapt the controller to your application as described in the documentation.
DANGER
!
• After the controller has been disconnected from the supply
voltage, live components and power connection must not be touched
immediately, since capacitors could be charged. Wait at least 60
seconds before servic-ing the drive Please observe the corresponding
notes on the controller.
• Do not continuously cycle input power to the controller more than once
every three minutes.
• Please close all protective covers and doors during operation.
WARNING!
Network control permits automatic operation of the inverter drive.
The system design must incorporate adequate protection to prevent
personnel from accessing moving equipment while power is applied to
the drive system.
Pictographs used in these instructions:
Pictograph
Signal Word
Meaning
Consequence if Ignored
DANGER!
Warning of Hazardous Electrical
Voltage.
Reference to an imminent
danger that may result in death
or serious personal injury if the
corresponding measures are
not taken.
WARNING!
Impending or possible danger to
personnel
Death or injury
STOP!
Possible damage to equipment
Damage to drive system or its
surroundings
NOTE
Useful tip: If note is observed, it
will make using the drive easier
