20
Accessory Decoder LS 100/110
“ERR 02”. Ignore this message, since LS100/LS110 is not able
to confirm successful programming to the command station.
Neither can you read out the values stored in the memory
locations.
Programming the settings of an output
In the following examples the settings of output 1 of
LS100/LS110 are programmed. Outputs 2, 3 and 4 are
programmed in the same manner, only with the corresponding
change of the storage location.
First connect the accessory decoder to the programming output
of the command station, as described above, and change into
programming mode with the hand held controller.
Select register 3. In this position the settings of output 1 are
stored (see Table 1).
Example 1: Setting pulse operation with shortest pulse duration.
As you see from tables 2 and 3 above, you must enter the
number 1 on hand held controller LH100 as the value to be
programmed. Then start the programming with the ‘Enter” key.
Example 2: Setting to constant on:
Enter 32 as the value to be programmed on hand held controller
LH100 (see Table 2). Start the programming sequence with the
‘Enter’ key.
By entering other values from table 3, you can choose to define
the other settings.
