Locomotive decoder LE230
13
DIGITAL plus
CV
R
e
g
Description
Range
Factory
setting
60
-
Decoder Configuration, byte 2:
Similar to CV 29, but other properties are set with this byte:
bit 1
Back EMF Control
If set back emf control is active
0,1
1
bit 2
Decoder Control Active
If set CV30 contains decoder error
0,1
1
bit 3
Brake momentum on DC operation.
This setting is only active with conventional DC
operation disabled. (CV 29, bit 3 = 0) This setting
can be used to achieve prototypical braking at red
signal indications.
0 locomotive proceeds with track voltage dependent
speed inside the conventional section.
1 locomotive brakes in the conventional section with
pre set brake momentum.
0,1
0
bit
4-8
not used
67
to
81
-
Values for user defined speed curve:
These registers are used for a user defined speed curve. The
factory setting for these registers is 0. If you are trying to
use this speed curve unmodified, your locomotive will not
move!
The value in each register determines the velocity of the
locomotive for each assigned speed step:
For the 14 speed step mode, speed step 1 is using the value
in CV 67, speed step 2 the value in CV 68, speed step 3 the
value in CV 69, etc.
For the 28 speed step mode, speed step 1 is using the value
in CV67, speed step 3 the value in CV 68, speed step 5 the
value in CV 69, etc. The intermediate speed steps are
calculated by the decoder.
0-63
0
