Do not use the heated trowel rail if the plug, power cable or heated towel rail
itself are damaged.
If the power cord is damaged, you must have it replaced at a service centre with
qualified persons in order to avoid a hazard.
Do not use the heated towel rail with a timer or separate remote control system.
Do not use the heated towel rail with an extension lead, power board or double
adaptor.
Plug the cord directly into an appropriate power point. To provide continued
protection against risk of electric shock, connect it to properly grounded power
points only.
Do not connect the plug into a power point which is exposed to splashing
The heated towel rail must not be located immediately below a power point.
Ensure that the heated towel rail is located at least 0.6 m from basins, bathtubs
and showers.
The heated towel rail is to be installed so that switches and other controls cannot
be touched by a person in the bath or shower.
Do not use the power cord under floor mats or carpet to avoid the danger of trip
hazard. Arrange the power cord away from traffic areas so that it will not be
tripped over by anyone.
Do not place any objects inserted into vents and exhaust ports, as it may cause an
electric shock, fire and damage the product.
Do not use the appliance in areas where gasoline, paints, or flammable liquids are
used or stored.
Use this product strictly as description in this manual to avoid the cause of fire,
electric shock, or injury to persons.
Unplug the heated towel rail while it is not in use or before cleaning.
Do not wrap the heated towel rail with towels, quilts when in use. Just lay the
towels and quilts on the unit.
This appliance is intended only for drying textiles washed in water.
OPERATING INSTRUCTIONS
1. Plug the power cord into a power point.
2. Press the power switch to the (l) position, the power indicator will light up and
the heated towel rail will start to work.
3.Press the power switch to the [o] position, the power indicator light will be off
and the heated towel rail will stop working.
CLEANING
1. Before cleaning, turn the heated towel rail off and disconnect it from the power
point. Allow it to cool down.
2. Do not put the product, power cord and plug into the water. Keep the cord dry.
3. Never clean the product with alcohol or solvent-based cleansers.
4. Clean the surface with a soft damp cloth first and then dry it with a soft cloth.
NOTE: Do not use a scourer or a rough cloth to wipe the towel rail, it will scratch
the surface of the product.
5. Do not us alcohol or solvents on plastic components, it will cause the cracking
and ageing of these parts.
SPECIFICATION
Power Source: 220-240 V AC, 50Hz, Class I
Rating Power Input :120W
Unit Size: 105 x 52 x 39 (H x W x D) cm
