-8-
Parts for which labor / Service is
NOT COVERED
- Following components
are simple to replace and DO NOT require a service technician. Therefore,
though the part is covered under the guidelines of the warranty agreement.
1- Panel
2- Jet cover, impeller and / or jet assembly
3- Faucet Cartridge, Shower Head
4- Footrest
5- Air actuate On/Off Button
6- Drain Plug
7- Remote control
During the Limited Warranty period, LENOX will, at its sole discretion, repair or replace any defective
component. All component parts removed under this Limited Warranty become property of LENOX.
And all replacement component/s MUST be return to LENOX. Within 20 days of replacement. If not,
replaced component/s will be charge as its cost/s.
This limited warranty is for the original owner and not transferable. The original owner agrees by using
pedicure spa the obligation of LENOX shall not extend to indirect or contingent damage or injury.
Furthermore, the obligations of LENOX are limited to those set forth herein. The limited warranty is the
exclusive remedy and is in lieu of all other warranties, express or limited, including but not limited to,
any implied warranty of fitness or merchantability for a particular purpose. No distributor or other person
has the right or authority to bind LENOX to changes to this limited warranty. Consequently, LENOX is
not responsible for such warranties or representations.
TO THE EXTENT ALLOWED BY LOCAL LAW, EXCEPT FOR THE OBLIGATIONS SPECIFICALLY
SET FORTH IN THIS WARRANTY STATEMENT, IN NO EVENT WILL LENOXOR ITS THIRD PARTY
SUPPLIERS BE LIABLE FOR ANY DAMAGED CAUSED BY LENOX’S PEDICURE SPA OR THE
FAILURE OF LENOXPEDICURE SPA INCLUDING ANY LOST PROFIT OR SAVINGS, BUSINESS
INTERRUPTION, LOSS OF USE OR ANY OTHER COMMERCIAL OR ECONOMIC LOSS OF ANY
KIND, OR SPECIAL, INCREMENTAL, OR CONSEQUENTIAL DAMAGES. THIS LIMITATION OF
LIABILITY APPLIES WHETHER DAMAGES ARE SOUGHT, OR A CLAIM MADE, UNDER THIS
LIMITED WARRANTY OR AS A TORT CLAIM, A CONTRACT CLAIM OR ANY OTHER CLAIM.
Limitation of liability
LENOX PEDICURE SPAS Limited Warranty (2/2)
USER MAINTENANCE INSTRUCTIONS CLEANING AND
DISINFECTING YOUR PEDICURE SPA
Note: Please be advised that it is responsibility of purchaser/user to adhere strictly to the
following procedure. Any non-compliance will be considered negligence of the purchaser/user.
The Bureau of barbering and cosmetology requires that salons using whirlpool pedicure spas use
the following disinfecting Procedures to ensure proper cleaning and maintenance of the equipment,
and to prevent bacterial infection. For your clients safety, always use the regulations as a minimum
standard for cleaning and disinfecting.
Chair maintenance:
Please see chair manual for Do and Don’t
A SPECIAL NOTE PERTAINING TO BLEACH
While bleach seems to be used extensively for cleaning and disinfecting of pedicure chair ba-
sins, it is NOT recommended nor is it effective. Moreover, excessive use of bleach may greatly
reduce the longevity of your pedicure chair internal components (i.e. pumps, jet waste assem-
bly, etc.). Excessive and repeated use of bleach may also void your warranty. As always, you
are required to check with your state board for mandatory cleaning and disinfecting require-
ments and procedures.
At the end of the day:
1. Remove the intake suction screen, All debris trapped behind the screen of each pedicure spa must
be removed. And the screen and the inlet shall be washed with soap or detergent and water
2. Before replacing the screen, Totally immersed the screen into an EPA- registered disinfectant with
bactericidal, Fungicidal, and virucidal activity.
3. Finally, flush the whirlpool system with low-sudsing detergent and warm OR an EPA - registered
cleanser for 10 minutes. Rinse with clean fresh water and drain.
Note:
Cleaning or sanitizing is NOT disinfecting. According to the CDC and EPA, disinfecting occurs only
when there is a reduction of pathogenic microbes at 99.999%. Sanitizing is a only reduction of 99.9%.
Cleaning of whirlpool pedicure spa requires surfactant and chelating detergents that are low foaming
and have ability to remove body oils, organic oil additives, mineral oil, skin cell, nail clippings, etc.. That
can accumulate both in the basin and the jets which may become fertile area for micro organism to
grow.
Note:
The use of oil based products can build up in the whirlpool system causing clogging in the jet and
build up onto the surface of the basin. Adherence to the above cleaning will minimize build up thus the
manufacturer recommend not to use mineral oil based product.
MAINTENANCE & CLEANING
LIMITED W
ARRANTY
