Lenovo ThinkSystem SR665, Руководство по установке

Страница: 231 / 268

Step 2. Install the top cover to your server.
Attention:
Handle the top cover carefully. Dropping the top cover with the cover latch open might
damage the cover latch.
Figure 110. Top cover installation
a. Ensure that the cover latch is in the open position. Lower the top cover onto the chassis until
both sides of the top cover engage the guides on both sides of the chassis. Then, slide the top
cover to the front of the chassis.
Note:
Before you slide the top cover forward, ensure that all the tabs on the top cover engage
the chassis correctly.
b. Pivot the cover latch until the top cover snaps into position. Ensure that the cover latch is
completely closed.
c. Use a screwdriver to turn the cover lock to the locked position.
Install a hot-swap power supply
Use this information to install a hot-swap power supply.
About this task
The following describes the information that you must consider when installing a power supply:
• The server is shipped with only one power supply by default. In this case, the power supply is non-hot-
swap and before removing it, you must turn off the server first. To support redundancy mode or hot-swap,
install an additional hot-swap power supply.
• If you are replacing the existing power supply with a new power supply:
– Use Lenovo Capacity Planner to calculate the required power capacity for what is configured for your
server. More information about Lenovo Capacity Planner is available at:
Chapter 4
.
Server hardware setup
227