Lenovo ThinkSystem HR650X, Руководство пользователя и руководство по техническому обслуживанию аппаратного обеспечения

Страница: 31 / 119

31
2.2.14 INSTALLING OR REPLACING A HOT-SWAP DRIVE
Do not proceed before reading and understanding the "Safety Precautions" section of this chapter and "Read Me First".
Note: The diagrams below are relevant for servers with 3.5-inch hard drive configuration only.
To remove a 3.5-inch hot-swap drive, do the following:
1. Gently push the release latch of the hot-swap drive (See Figure below) to open the handle of the drive.
Pushing the release latch of a 3.5-inch hot-swap drive
2. Rotate and pull the handle to slide the drive out of the chassis.
Removing a 3.5-inch hot-swap drive
To reinstall, reverse the steps above.
Special Note: Install the hot-swap drives into the available bays in the order numbered in the diagrams below. Install dummy trays in all
vacant hot-swap drive bays.
Order of installation for 3.5-inch hot-swap drives
0
1
2
3
4
5
6
7
8
9
10
11