Lenovo ThinkStation P360 Tower, Руководство по техническому обслуживанию аппаратной части

Страница: 111 / 116

Note: The microprocessor socket cover might look slightly different from the illustration.
3. Carefully check the four corners of the socket cover to ensure that the cover is seated securely.
4. Follow any additional instructions that are included with the replacement part you received.
VRM heat sink
Prerequisite
Before you start, read Generic Safety and Compliance Notices , and print the following instructions.
The heat sink and microprocessor might be very hot. Before you open the computer cover, turn off the
computer and wait several minutes until the computer is cool.
For access, do the following:
1. Remove these parts in order, if any:
• “Computer cover” on page 53
• “Optical drive” on page 54
• “Front bezel” on page 55
• “Primary hard disk drives” on page 56
• “PCI-Express card” on page 62
• “Graphics card fan” on page 63
• “Graphics card holder” on page 64
• “Graphics card” on page 65
• “M.2 solid-state drive and heat sink” on page 69
• “Optical drive cage” on page 74
• “Front fan” on page 82
• “Rear fan” on page 83
• “Heat-sink-and-fan assembly” on page 84
• “Chassis beam” on page 88
• “Memory module” on page 89
• “Coin-cell battery” on page 92
• “E-lock” on page 92
• “Front I/O bracket, power button cable, and card reader” on page 93
• “Internal speaker” on page 95
• “Wi-Fi card” on page 96
• “Cover presence switch cable and bracket” on page 101
• “Microprocessor” on page 102
• “System board” on page 50
2. Turn over the system board.
Chapter 7
.
Hardware removal and installation
105