Lenovo ThinkCentre 7570, Руководство по техническому обслуживанию аппаратной части

Страница: 114 / 208

9. Disconnect the front panel control board cable from the system board. Lift the front panel control
board off the front bezel.
10. Position the new front panel control board on the front bezel and align the screw holes in the new
power switch module with those in the front bezel.
11. Connect the new front panel control board cable to the system board.
12. Install the three screws that secure the new front panel control board to the front bezel.
13. Install the 21 screws to secure the main bracket to the front bezel.
14. Connect all the cables that were disconnected. See “System board parts and connectors” on page 71.
15. Go to “Completing the parts replacement” on page 113.
Replacing the system board
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety
information” in the
ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy
of the ThinkCentre Safety and Warranty Guide , go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the system board.
To replace the power system board, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See “Removing the computer cover” on page 73.
4. Locate the system board in the computer. See “FRU locations” on page 69.
5. Remove the hard disk drive. See “Replacing the hard disk drive” on page 74.
6. Remove the wall mount. See “Removing or reinstalling the wall mount” on page 82.
108
ThinkCentre Hardware Maintenance Manual