Lenovo ThinkCentre 7570, Руководство по техническому обслуживанию аппаратной части

Страница: 104 / 208

6. Carefully release the Bluetooth module and lift the Bluetooth module out of the computer.
Figure 30. Removing the Bluetooth module
7. Position the new Bluetooth module into the computer front bezel, and then press the new Bluetooth
module downward until it is secured into place.
8. Connect the new Bluetooth module cable to the system board. See “System board parts and
connectors” on page 71.
9. Go to “Completing the parts replacement” on page 113.
Replacing the multi-touch board
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety
information” in the
ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy
of the ThinkCentre Safety and Warranty Guide , go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the multi-touch board.
Note: The multi-touch board is available only in some models.
To replace the multi-touch board, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See “Removing the computer cover” on page 73.
4. Locate the multi-touch board in the computer. See “FRU locations” on page 69.
5. Note the multi-touch board cable routing and disconnect the three multi-touch board cables from
the system board and the multi-touch screen.
6. Carefully remove the two screws 1 that secure the multi-touch board, and then lift the multi-touch
board off the computer main bracket.
98
ThinkCentre Hardware Maintenance Manual