52
SI4093 System Interconnect Module User’s Guide
Installing Feature Licenses
Once Features on Demand activation key files have been acquired, they must be
installed on the switch. The example below illustrates use of the switch CLI, but
other interfaces may also be used, such as Simple Network Management Protocol
(SNMP). For more information, see the
Application Guide
and
Command Reference
for your specific switch and its installed firmware.
When installing licenses, please note the following requirements:
A switch reboot is required to fully activate the license(s). If you have made any
configuration changes you wish to persist beyond the reboot, you must execute
the
copy
running-config
startup-config
command. This command
stores the current switch configuration and all changes to nonvolatile memory.
Both license key files can be installed prior to the switch reset in order to activate
both at the same time.
Complete the following steps to install feature licenses:
1.
Log in to the switch (see
“Configuring the SI4093” on page 37
for more
information).
2.
At the switch CLI prompt, type the following command.
where
server address
is the IP address of the TFTP or SFTP file server, and
file
name
is the name of the licence key file as it appears in the file server operating
system.
3.
Once the key file transfer is complete, reset the switch to activate the license(s) (see
“Resetting and Restarting the Switch” on page 50
).
SI 4093>
enable
SI 4093#
software-key
SI 4093(Software-Key)#
enakey addr
<server address>
keyfile
<file name>
protocol
{tftp|sftp} {data-port|extm-port|mgt-port}
Содержание SI4093
Страница 1: ...Lenovo Flex System Fabric SI4093 System Interconnect Module User s Guide ...
Страница 14: ...14 SI4093 System Interconnect Module User s Guide ...
Страница 36: ...36 SI4093 System Interconnect Module User s Guide ...
Страница 44: ...44 SI4093 System Interconnect Module User s Guide ...
