NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
10
The lower access
door hinges open
to access Valve
Controls
Lower Access
Door
Figure 12
Step 8: INSTALL LOWER ACCESS DOOR
.
Install the lower access door by inserting the
tabs on the door sides into the corresponding
holes on the brackets on the stove bottom
(see
Figure 12
below)
Step 9: VENTING SYSTEM INSTALLATION
INSTALL VENTING COMPONENTS PER
VENT MANUFACTURERS INSTRUCTIONS
The vent system may not service multiple
appliances, and must never be connected to a
fl ue serving a solid fuel burning appliance.
CAUTION: Under no circumstances should
these appliances be vented to other rooms
or buildings. These appliances must only be
vented to the outside. Vent terminations shall
not be recessed into a wall or siding.
IMPORTANT: Do not exceed the maximum
horizontal run allowed (see
Figures 13 and
14).
Support Brackets - Install vent support brack-
ets as specifi ed in the vent manufacturers
instructions and the National Gas Fuel Code,
USA - NFPA 54 / ANSI Z223.1, 7.6.5 Support
of Gas Vents. Gas vents shall be supported and
spaced in accordance with their listings and
the (vent) manufacturer instructions.
General Information: These instructions
should be used as a guideline and do not
supersede local codes in any way. Install vent
according to local codes, these instructions,
the current National Fuel Gas Code (NFPA
54 / ANSI-Z223.1) in the USA or the current
standards of CAN/CGA-B149.1 and -B149.2
in Canada.
These stoves are designed, tested and listed for
operation and installation with, and only with,
"Security Secure Vent
TM
" or "Simpson Dura
Vent" brand Components (co-axial DV pipe
with 4" inner and 6-5/8" outer diameter).
These approved vent system components are
labeled for identifi cation. DO NOT use any other
manufacturer's vent components with these
appliances. These stoves must be vented directly
to the outside.
