NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
9
Figure 16
A
B
D
E
C
(Notch)
(Notch)
A
B
D
E
C
DO NOT USE THIS FIREPLACE IF ANY PART
OF IT HAS BEEN UNDERWATER. IMMEDI-
ATELY CALL A QUALIFIED SERVICE TECHNI-
CIAN TO INSPECT THE FIREPLACE AND RE-
PLACE ANY PART OF THE ELECTRICAL SYS-
TEM WHICH HAS BEEN UNDER WATER.
HARD (DIRECT) WIRE CONNECTION
If desired, a qualified electrician may remove
the cord connection and wire this unit directly
to the household wiring.
Any electrical re-wiring of this appliance
must be done by a qualified electrician.
INSTALLING THE LOGS
1.
Turn off power to the unit.
2.
Place Log Assembly
A
on the grate first and
center it against the back of the grate, engag-
ing the notch at the bottom right hand side of
the log assembly to the right grate bar. The
correct placement of Log Assembly
A
is im-
portant to provide the proper visual effect.
Placement of the other logs can be adjusted to
suit individual taste. Our suggested place-
ment is shown in
Figure 16.
Note: Log
D
is provided with a notch on its
bottom side to be engaged over the left grate
bar. Log
E
should be placed in the cradled
depression in the middle of the ember bed,
charred end to the left.
SERVICE INSTRUCTIONS
This appliance has been designed to provide
many years of trouble free service. The com-
ponents that will need to be serviced have been
kept to a minimum. Periodic dusting of the
glass and display is all that should be required.
CAUTION: DISCONNECT POWER BEFORE
ATTEMPTING ANY MAINTENANCE OR
CLEANING TO REDUCE THE RISK OF FIRE,
ELECTRICAL SHOCK OR PERSONAL INJURY.
GLASS FRAME REMOVAL
To access the logs, grate embers and lights,
the glass panel needs to be removed. An
illustration of the glass panel installation is
shown in
Figure 13
.
First sweep the screens inward and tie up and
out of the way. The glass is not secured by any
fasteners. The back rests on two insulated
tabs and the front is hooked behind a lip.
CAUTION: WHEN REMOVING THE GLASS,
DO NOT LET THE BACK OF THE PANEL SLIP
OFF OF THE INSULATED TABS IN THE BACK.
THIS COULD ALLOW THE GLASS TO DROP
INTO THE REFRACTORY PANELS OR LOGS
AND BREAK THEM.
The lower front corners of the glass are
exposed to provide a place to grip the glass
panel. Grip the corners firmly; lift the panel
back and up against the top of the unit.
Disengage the glass from behind the front
lip and rotate the front upwards. Slide one
hand under the glass and support the panel.
Draw the glass out of the unit and set it
carefully aside.
GLASS INFORMATION
1.
This unit will not operate properly with
missing or broken glass.
2.
Do not strike or slam the glass.
3.
Do not use abrasive cleaners to clean the
glass.
4.
This appliance uses tempered glass. Re-
placement of the glass as supplied by the
manufacturer should be done by a qualified
service technician.
Figure 17
MANUAL OPERATION
Switches have been placed on the unit to allow
operation without the remote.
Switches are in the upper right hand corner
of the face opening behind the screen (
see
Figure 17
).
The pad labeled
P
nearest the center will turn
the fireplace on and off. The pad to the right
of that, labeled
H
, will turn the heater on and
off.
Note:
The heater will not operate without the
unit ON.
