NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
10
REMOTE CONTROL OPERATION
The Reflections Electric Fireplace is provided
with an Infrared Remote Control. All func-
tions of the fireplace are provided through the
remote.
The remote provided with the T.V.
should not be used
.
The functions identified on the remote (see
Figure 18
) are as follows:
A. All ON/All OFF
Press once; the embers light and the flame
come on after a brief warm up period. Pressed
again and all functions end immediately.
B. Embers ON/OFF
This button will turn the embers ON and OFF
independent of the main button.
C. Menu
To activate the menu for adjusting color and
brightness.
D. Heater ON/OFF
This button will turn the heater ON and OFF after
the unit is activated.
E. Volume
Increase:
Decrease:
F. Setting Control
Increase:
Decrease:
G. Flame Speed
Alternates between fast and slow flame speed.
COLOR ADJUSTMENT
To adjust Color, Tint and Brightness, use the
Menu (button
C
) along with
E
and
F
as follows.
The menus displayed will be upside down and
backwards. This is a step that should only be
required once.
REPLACING LIGHT BULB
This fireplace uses a 120 Volt, compact fluo-
rescent light bulb (900 Lumens). The light is
located under the ember bed of the unit.
CAUTION: DO NOT EXCEED A 15 WATT BULB.
USE OF A HIGHER RATED BULB MAY RESULT
IN A FIRE, CAUSING PROPERTY DAMAGE,
PERSONAL INJURY OR LOSS OF LIFE.
CAUTION: DO NOT REPLACE THE COMPACT
FLUORESCENT LIGHT BULB WITH AN IN-
CANDESCENT BULB.
1.
Turn off power to the unit.
2.
Let the fireplace cool, if it has been operating.
3.
Remove the glass reflector panel. Remove
logs and ember bed.
4.
Examine the bulb to determine if it needs to
be replaced.
5.
While holding the socket, unscrew the de-
fective bulb.
6.
Install the new light bulb by screwing it in
while holding the socket.
7.
Reinstall the ember bed, log set and glass
panel.
PICTURE ADJUSTMENT
The television will come with all adjustments
at normal. If you wish to enhance the color,
adjustments can be made.
Step 1.
Press the
MENU
button so that the
menu display appears on the TV screen.
Step 2.
Press the
VOL
(ume) button so
that "PICTURE" is selected.
Step 3.
Select the feature you wish to adjust
with the
MENU
or button and adjust
it with the
VOL
(ume) or button.
BRIGHT
Adjust until the whitest parts of the picture are
as bright as you prefer.
: Increase Brightness,
: Decrease
Brightness
CONTRAST
Adjust to increase or decrease contrast.
: Increase Contrast,
: Decrease
Contrast
COLOR
Adjust to be a brilliant or pale color.
: Be Brilliant Color,
: Be Pale Color
TINT
Adjust to obtain natural flame tones.
: Greenish Tone,
: Reddish Tone
TROUBLESHOOTING
Due to the nature of all electronic devices,
interference from other electrical sources
could set the units out of phase. The televi-
sion and DVD player could operate with one
ON and the other OFF rather than both ON,
both OFF. If this occurs, the television can be
turned ON (or OFF) manually with the button
(
shown in
Figure 18
). This will put the units
back in sync from that point forward.
Figure 18
F
G
E
A
D
B
+
–
+
–
+
–
+
–
+
–
C
–
+
