9
Remote Control Batteries
The wireless remote control requires two AAA, 1.5V batter-
ies. DO NOT attempt to use any other type of battery.
Follow the steps below and in the illustrations to replace the
batteries when necessary.
1 −
Place thumb on at the top of the battery access
panel on the back of the remote control. Slide the panel
in the direction of the arrow.
2 −
Remove the existing AAA, 1.5V batteries.
3 −
Replace batteries with fully charged AAA, 1.5V batteries.
NOTE − Pay attention to proper polarity of batteries. Re-
mote control will not operate if batteries are improperly
installed.
4 −
Reposition battery access panel and slide forward until
panel snaps into locked position.
IMPORTANT !
If wireless remote will not be used for a long period of
time, remove batteries to avoid damage to the control.
The remote control must be placed on a table or other sur-
face in direct line of sight with the indoor unit infrared re-
ceiver. The control should not be placed in a drawer. Make
sure that there are no obstructions between the indoor unit
receiver and the remote control.
Remote should remain within its receiving range to ensure proper system control.
Control should be kept at least 3 feet (914mm) away from other electrical appliances
(televisions, stereos, etc.) to prevent signal interference.
If remote control operation becomes erratic, remove batteries. Wait 30 seconds and
reinsert batteries. If proper remote operation is not restored, replace batteries.
Auto ON Switch
If the remote control is lost or damaged, or if
charged AAA, 1.5V batteries are not avail-
able, the Auto ON switch can be used to turn
the system on or off.
The Auto ON switch is located behind the
cover panel on the indoor unit. Lift the front
panel and press the ON button once briefly to
start the system. To stop emergency opera-
tion, push the ON button again.
IMPORTANT !
The Auto ON button initiates operation in
the AUTO mode. The temperature and fan
speed are not adjustable in the AUTO
mode.
AUTO
PENCIL OR OTHER
NON−METALLIC OBJECT
AUTO BUTTON
PRESS
WITH
FINGER
AUTO Switch
(Recessed)
AUTO Switch
(Not Recessed)