Lennox M0STAT64Q, Инструкция по установке и эксплуатации

Страница: 6 / 16

6
2. Select the cable exit route from the back of the
controller. See figure 8.
Figure 8. Select Cable Route
PCB
PCB
PCB
1
1
1
2
3
¹Use snips to notch the
controller casing to allow
the cable to pass through.
3. Include a drip loop in the cable. See figure 9.
4. Seal the cable entrance to the controller cas-
ing and any wall penetrations to prevent water
from entering the controller. See figure 9.
Figure 9. Prevent Water from Entering Con-
troller Casing
Sealant
Drip
Loop
Drip
Loop
Drip
Loop
Sealant
Sealant
5. Reattach the controller to the back plate. Be
careful not to pinch or bind the wires. See fig -
ure 10.
Figure 10. Reattach Controller to Back Plate