Lennox icomfort Touch, Руководство по установке

Страница: 6 / 44

506566−01 09/10
Page 6
Adding or Removing Non−Communicating Equipment
Add or Remove Non−Communicating Equipment
Use this option to add any non−communicating outdoor unit
and any non−communicating accessory. Press the
yes button
on this screen (figure 10) to access a list of non−communicat-
ing devices to be installed or removed. A list similar to that
shown in figure 11 will appear.
setup HELP
Add or Remove
Non−communicating
equipment?
If no, then press
next step"
system devices
next step
yes
back
Furnace
SLP98UH−
090V36C−01
5910G17546
Thermostat
49W95
A110A00070
System
49W95
Figure 10. Add/remove non−communicating de-
vices screen
Adding a Non−communicating Outdoor Unit
Non−communicating air conditioning unit or heat pumps are
added to the icomfort system as follows:
1. Select Add or Remove Non−communicating equipment
by pressing yes (see figure 10).
2. Use arrows to highlight Outdoor Unit Type and press
edit (see figure 11). Then use arrows to highllight 1 Stage
AC Unit or 2 Stage AC Unit; press save (see figure 12).
setup HELP
non−communicating
device list
Outdoor Unit
Type
Humidifier
Dehumidifier
Electronic Air
Cleaner
to adjust a setting, high-
light it, then press edit
Current Value:
Not Installed
back
edit
Figure 11. Installing non−communicating outdoor
unit
Outdoor Unit Type
default is underlined
current value is checked
save cancel
Not Installed
1 Stage A/C Unit
2 Stage A/C Unit
Figure 12. Defining non−communicating outdoor
unit type
3. Change any red settings (e.g. Outdoor Unit Capacity) by
selecting the setting and press edit . Use up/down arrows
to make changes; then press save . Change any other
red settings (if present) using a similar process to com-
plete installation of the device.
NOTE − Non−communicating heat pumps are adding using a
similar process by selecting 1− or 2−Stage HP Unit under the
Outdoor Unit Type.
Adding UV Light, Electronic Air Cleaner
Adding accessories including UV Light and Electronic Air
Cleaner is a simple process of installing" the device, which
effectively tells the thermostat to activate access to its service
timers.
Select the device from the list and press edit . Use the up/
down arrows to scroll from Not Installed" (default) to the de-
vice name. Press
save .
Adding humidifier and dehumidifier
NOTE − Adding humidity−related non−communicating devices
may be a two−step programming procedure:
First , the device must be installed and saved.
Second , the device may also need to be configured (if
Basic" mode is not the desired setting) and saved (see
Page 8).
See the following page for humidifier and dehumidifier instal-
lation and configuration.