10
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Zero Clearance Fireplace Installation
This insert may be installed in a masonry or factory built/zero clearance
(ZC) fireplace. When installing in a ZC fireplace, the ZC grate must be
removed and the ZC damper must be removed or secured open. The ZC
doors, screen, refractory or masonry lining, baffles and smoke shelf may
be removed, if necessary, to install the gas insert. However,
do not cut
or alter the fireplace components
. The removal of any parts to facilitate
installation must not alter the integrity of the inner or outer shells of the
fireplace cabinet. See Fireplace Requirements on
Page 5
.
Glass Door Removal
See
Page 20
for Glass Door Removal Instructions.
Brick Liner Installation
HANDLE THE BRICK PANELS WITH CARE (SEE FIGURE 8) AS
THEY ARE FRAGILE. DO NOT FORCE THE PANELS INTO THE
FIREBOX AS THEY WILL BREAK IF FORCED.
1. Open and remove glass door, see “Front Door Removal”
2. The longest panel goes in the rear of the firebox. Tilt the top of the
panel forward, insert the bottom of the panel in the brick panel retainer
and push the panel to the up-right position.
3. Install the side panels by sliding the top of the panel into the top side
brick retainer and then dropping the bottom of the panel into the bot-
tom retainer. The rounded edge on the side brick panels goes toward
the front.
3
-Piece Brick Panel Set
The size and position of the log set is critical to achieve a safe,
reliable and attractive flame pattern. Any attempt to use a differ-
ent log set in the fireplace will void the warranty and will result
in incomplete combustion, sooting and poor flame quality.
Part list: Rear log, Right Front log, Left Front log and Top Twig
1. Remove the logs from the box and carefully unwrap them. The logs
are fragile, so handle them with care.
2. Place the rear log with the charred surface forward, on the two rear
locating pins (see
Figure 9
).
3. Place the left front log, with the charred surface forward, (see
Figure
10
) on the two left front locating pins. Next place the right front log,
with the charred surface forward, on the two right front locating
pins.
Continued on
Page 11
...
Right Front Leg
Figure 2
Left Front Leg
Figure 1
Rear Log
Right Front Leg
Figure 2
Left Front Leg
Figure 1
Rear Log
Rear Log
Left Front
Log
Right Front
Log
Figure 8
Figure 10
Figure 9
Log Installation Instructions
If logs are not installed according to the log installation instruc-
tions, flame impingement and improper combustion could
occur and result in soot and/or excessive production of carbon
monoxide (CO), a colorless, odorless, toxic gas.
Содержание FIRESTAR MERIT GC3
Страница 27: ...27 NOTES...
