Lennox e-Lite, Инструкция по установке и эксплуатации

Страница: 6 / 24

Caution
4
Figure 3.3
• All bolts should be made from high quality carbon steel (with
galvanized surface or other rust prevention treatment) or
stainless steel.
Newly set concrete slab structure
Set using embedded appliances, and embedded type of bolts.
Knife-type
insertion piece
Sliding-type
insertion piece
Reinforced bar
Embedded bolt
(hanging and embedded
bolt for piping)
3.2 Mounting for return air at the side (uncovered)
Figure 3.4
Figure 3.5
2) Determine and clearly mark the mounting location on the wall
based on the positions of the mounting holes of the unit body (may
also refer to the data in Table 3.1).
3) At the marked positions on the wall, use electric drill to drill 4 holes
that are Φ6 mm, and 40 mm deep each. Then use 4 X M6 expan-
sion bolts to secure the unit body.
Follow the instructions below to mount and install:
1) Dismantle the panel, and follow the instructions described in the
following diagram to remove the structure and fix the screws.
Figure 3.6
B
A
C
Capacity
(kW)
2.2 ~ 2.8
3.6 ~ 4.5
5.6 ~ 8.0
A(mm) B(mm)
1200
1500
1000 225
225
225
C(mm)
596
596
596
Table.3.1
Dimensions of unit
3.3 Mounting for return air at the bottom (uncovered)
Figure 3.7
2) Put the air conditioner on the mounting bracket, and secure it with
screws (refer to Figure 3.8).
3) Determine and clearly mark the installation location on the wall
based on the positions of the installation holes of the unit body
(may also refer to the data in Table 3.2).
4) At the marked positions on the wall, use electric drill to drill 4 holes
that are Φ6 mm, and 40 mm deep each. Then use 4 X M6 expan-
sion bolts to secure the unit body.
Follow the instructions below to mount and install:
1) Dismantle the panel, and follow the instructions described in the
following diagram to remove the structure and fix the screws:
149.5
149.5
Right
Cover
Air outlet grille
Left
Cover
Air inlet grille