Page 2
506960−−01 02/12
Installation
ENHANCED
BALLAST
CORD
LAMP CORD
CONNECTOR
DISCONNECT
CONNECT
Figure 1. Disconnect/Connect Lamp Cord
LOCK POSITION
ALIGN
POSITION
LAMP
BASE
LAMP
HOLDER
1" HOLE
ROTATE TO UNLOCK
Figure 2. Removing the lamp holder assembly
1. Turn off power to the lamp before removing the cord.
2. Disconnect the lamp cord as shown in figure 1.
3. Unlock the lamp holder as shown in figure 2. Set the
lamp holder and lamp aside.
4. Remove the lamp base as shown in figure 3.
5. Install new lamp base assembly as shown in figure 3.
LAMP BASE
MOUNTING
SCREWS
I INCH
HOLE
Figure 3. Remove and Install Lamp Base
BAFFLE
TROUGH
LAMP
SCREWS
MOUNTING
SURFACE
LAMP BASE
GUIDE LAMP TIP ALONG
THE SURFACE OF THE
TROUGH
LAMP
HOLDER
BAND
CLASP
Figure 4. Guiding Lamp into Shielding Baffle
6. Align arrow on lamp holder with arrow on lamp base.
Insert lamp holder into base (see A in figure 5).
7. Twist to align lamp holder arrow with lock symbol (see
LAMP
BASE
APPROX.
30 DEG.
ROTATION
A
B
Figure 5. Locking Lamp in Place
8. Connect the lamp holder cord’s quick connect to the
mating enhanced ballast connector (see figure 1).
9. Turn on power and check operation and that LEDs on
ballast are lit.
