Lennox EMEA Euromon 100 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 28

For viewing the minimum temperature set. In programming mode it enables the parameter list to be
browsed or the value displayed to be reduced.
If this button is pressed and held down for 3 seconds, the defrost cycle begins.
For switching the cold room light on or off.
For switching the unit on or off.
3.6. CONTROL FUNCTIONS
•
To switch the unit on or off.-
2. press the button. “ OFF ” will appear for 5 s.
•
To view the maximum temperature set.-
1. press the button.
2. the value will appear on the screen together with the message “ Hi ”.
3. press the button and hold it down for 5 seconds to exit.
•
To view the minimum temperature set.-
1. press the button.
2. the value will appear on the display together with the message “ Lo ”.
3. press the button and hold it down for 5 seconds to exit.
•
To erase the maximum and minimum temperatures set.-
1. while the minimum or maximum temperature is being displayed,
2. press the button and hold it down until the message “
rST ” appears.
•
To view and change the setting.-
1. press the set button briefly to view the setting
2. The corresponding indicator light will start to flash.
3. press the or buttons to change the value.
4. to complete the process, press set or wait for 10 seconds.
•
To start a manual defrost cycle.-
1. press the button and hold it down for 2 seconds.
•
To access the Pr1 list of user parameters.-
1. press the set and buttons and hold them down for a few seconds,
2. the fan and compressor indicator lights will begin to flash,
3. the first parameter on the list will appear on the display.
•
To change a parameter.-
1. enter the parameter list,
2. select the desired parameter using the or buttons, and press set to view its value.
CAUTION
After installing and starting up the unit, do not forget to set the maximum and minimum
temperatures.
14